Honeywell GSMX4G Installation And Setup Manual page 11

GSMX4G / GSMXCN4G Installation and Setup Guide
Audio
Connector
ECP Cable
PANEL DATA OUT - Yellow
To ECP Bus
on control panel
circuit board.
4. Connect the ECP cable to the communicator circuit board. When
mounting the communicator off the cabinet, the length of the sup-
plied ECP cable will have to be spliced to a four-wire extender cable.
Ensure the splices are located within the communicator's
enclosure.
Use the table below to determine the minimum wire gauge for the
extender cable.
Minimum Wire Gauge
#22
#20
#18
#16
5. Route the wires through the rear wiring access hole or bottom
knockout on the communicator. Continue routing the wiring to the
control panel. A control panel knockout that is presently used can be
AUX PWR (+12V) - Red
GND - Black
PANEL DATA IN - Green
Distance from Control Panel
75 ft (23m)
120 ft (37m)
170 ft (52m)
270 ft (82m)
– 9 –
Mounting
Hole (2)
Wiring
Access
Hole
Hole
Cap