Honeywell GSMX4G Installation And Setup Manual page 23

GSMX4G / GSMXCN4G Installation and Setup Guide
PROMPTS ENTRY
23
only
Open/
Close
4204
Zone (0)
2-4204
24 only
Restore
Zn1 Y/N 4204
2-4204
(Y)
25 only
Delay Zn1
(secs)
4204
2-4204
(00)
26 only
Rpt Zn1
ONLY if 4204
Armed
2-4204
(N)
27 only
Restore
Zn2 Y/N 4204
2-4204
(Y)
28 only
Delay Zn2
(secs)
4204
2-4204
(00)
OPTIONS
Enter the zone number to be used
4204: [1-4]
for open/close (arm/disarm)
2-4204:
reports. This zone assignment
[1-8]
must be unique from the Telco
[0] = not
zone selected in Prompt 22.
used
4204 Mode: If any zone is
programmed for "report only if
armed," zone 4 cannot be used
as an open/close zone.
2-4204 Mode: If any zone is
programmed for "report only if
armed," zone 8 cannot be used.
NOTE: Connect an open/close
(arm/disarm) trigger (or relay
output) from the control panel to
the open/close zone.
[Y], [N] Enables restore reporting for
zone 1.
[01-15]
Defines the reporting delay in
seconds for zone 1.
[00] = no
delay
Reports alarms on zone 1 ONLY
[Y], [N]
if the conditional zone (zone 4 in
4204 mode; or zone 8 in 2-4204
mode) is triggered (armed).
If [N], always reports alarms on
zone 1.
[Y], [N] Enables restore reporting for
zone 2.
[01-15]
Defines the reporting delay in
seconds for zone 2.
[00] = no
delay
– 21 –
DESCRIPTION