Using A 7720P Programming Tool; Normal And Shift Key Functions Table; Using The Control Panel Programming Mode - Honeywell AlarmNet 7845GSM Installation And Setup Manual

7845GSM/7845GSMCN Installation and Setup Guide

Using a 7720P Programming Tool

Connect the 7720P Programming Tool as shown below. The 7845GSM powers the 7720P
Programming Tool via the programming jack, and automatically senses the presence of the
7720P when it is plugged in.
Each key of the 7720P has two possible functions: a normal function and a Shift function.
To perform a normal key function, simply press the desired key.
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. Table 2 below lists
each normal and shift key function.
KEY
BS/ESC
↓/↑
N/Y
SHIFT
1/A
2/B
3/C
4/D
5/E
6/F
7/S
8/T
9/X
SPACE
0
#/ENTER
*Active only when the "Exit Programming Mode" prompt is displayed.

Using the Control Panel Programming Mode

Some control panels support programming of the 7845GSM through the control panel
programming mode (e.g., Vista-128BP). If programming through the control panel, only
the ECP Mode programming options are available. The "mode" questions will not be
displayed, and the mode cannot be changed. For a description of key functions on the
3-2
WWW.DIYALARMFORUM.COM
PROGRAMMING
Figure 10. Cable Connections
Table 2. 7720P Normal and Shift Key (shift LED lit) Functions
NORMAL KEY FUNCTION
[BS]: Press to delete entry
[↓]: Scroll down programming
[N]: Press for "NO" answer
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key
is pressed. Press again for each SHIFT function desired.
[1]: For entering the number 1
[2]: For entering the number 2
[3]: For entering the number 3
[4]: For entering the number 4
[5]: For entering the number 5
[6]: For entering the number 6
[7]: For entering the number 7
[8]: For entering the number 8
[9]: For entering the number 9
[SPACE]: For scrolling option list
[0]: For entering the number 0
[#/ENTER]: Starts programming mode;
Press to accept entries
WWW.DIYALARMFORUM.COM
Xmit
Shift
7720 PROGRAMMING TOOL
A
BS / ESC
1
/ D
4
N / Y S
7 8
Shift Space
0
LEDs
7720P
JACK
RSSI / MODE AND
STATUS LEDs
TB1
MODE AND STATUS
INDICATOR SWITCH
TAMPER
J1
SWITCH
BATTERY
CONNECTOR
SHIFT KEY FUNCTION
[ESC]: Press to quit program mode; also can reset
programming defaults*
[↑]: Scroll up programming
[Y]: Press SHIFT-Y for "YES" answer
[A]: For entering letter A
[B]: For entering letter B
[C]: For entering letter C
[D]: For entering letter D
[E]: For entering letter E
[F]: For entering letter F
[S]: For entering letter S
[T]: For entering letter T
[X]: For entering letter X
No SHIFT function
No SHIFT function
No SHIFT function
B C
2 3
E F
5 6
T X
9
Enter
#
INTERNAL
ANTENNA
7845GSM-005-V1