Carrying Out The Initial Set Up Of The Solar-Log 200, 250 And 300; Initial Set Up Of The Solar-Log 1200 - Solar-Log 200 Installation Manual

14.2.1 Carrying out the initial set up of the Solar-Log 200, 250 and 300.

The initial configuration of Solar-Log 300 is made via the web browser menu.
Procedure:
•
Enter the address http://solar-log
•
A selection of display languages is displayed.
•
Select the desired Display Language
•
The welcome screen then appears.
•
In the navigation bar at the top, click on
•
The following menus have to be configured:
Internet (Chapter 17 on page 87)
Network (Chapter 16.1 on page 79)
Device (Chapter 18 on page 91)
Plant (Chapter 19 on page 104) and
System (Chapter 22 on page 124)

14.3 Initial set up of the Solar-Log 1200

The initial configuration of Solar-Log 1200 can be made via a Web browser or via the touch display.
See Chapter 26.4.1 for details on configuring the device.
Requirements
•
All cables and accessories (if any) have been connected to the Solar-Log 1200.
•
The Solar-Log 1200 is connected to an Internet router.
•
The DHCP service is enabled on the Internet router.
•
The DHCP service is also enabled on the PC or laptop.
Easy Installation
After selecting the language and country, the initial set up can be carried out with the "Easy Installation"
configuration wizard. However, Easy Installation can currently only be used with certain inverters. Depend-
ing on the country, different inverter brands are integrated into the Easy Installation mode.
The Solar-Log TM then carries out the initial set up intuitively step by step.
For more information, please refer to the Quick Start Guide that was included with the device.
in the address bar of the web browser.
.
Configuration .
Installation
67