Fault Messages Time; Fault Messages Wifi - Solar-Log 200 Installation Manual

28.2.2 Fault messages time

These fault messages are displayed on the LCD display
Fault messages
Time
Error code
1
TM

28.2.3 Fault messages WiFi

These fault messages are shown in the LCD display and also in the Status box under
work | WiFi
.
Fault messages WiFi
Error code
10
11
12
20
21
30
99
Message
No time/date set
Message
Initialization error
Incorrect WiFi configura-
tion
Error while initializing the
wireless LAN module
Error while connecting
No access point found
Authentication failure
Unknown error
Possible cause or remedy
Set the time and date or use the automatic time
synchronization function
Just like error 1
The names have been changed with Firmware
3.0.2.
Possible cause/remedy
Please check if all of the required param-
eters were configured.
Potential hardware failure. Contact tech-
nical support
The signal is too weak. Other network
signals are interfering with the connec-
tion.
The access point is turned off or not
available. The SSID was entered incor-
rectly.
The network key entered is incorrect.
The encryption type entered is wrong.
An unexpected error occurred. If this
error continues to occur, contact our
technical support.
Configuration | Net-
Faults
191