Device Notifications; Fig.: Status And Fault Code Groups - Solar-Log 200 Installation Manual

Configuring Notifications

20.2 Device notifications

If certain status or fault codes occur, Solar-Log™ can send messages by e-mail or text message (SMS).
The Solar-Log™ retrieves fault messages from the connected inverters. Therefore, the status and fault
codes can vary depending on the inverters installed.
The codes are always divided into two groups.

Fig.: Status and fault code groups

In group A, inverter specific messages are numbered in ascending order, starting with 0. The code which is
automatically determined is used for the filter function.
In group B, the actual messages from the inverters are displayed. The meaning of these fault messages can
be found in the particular manufacturer's manual.
Note!
Open the dialog box
Configuration | Notifications | Device messages
Select
This is divided into the following sections:
•
Device
•
Status codes
•
Fault codes
•
Filter
Status and fault codes section
The status and fault codes that are available depend on the inverter type. To find out which status and
fault codes are relevant for automatic messaging, please refer to the inverter user manual.
110
When making support inquiries
group B
sages from .
with the inverter manufacturer, please use the mes-
from the menu.