Easy Installation (Only Solar-Log 1200); Fig.: Display: Start Easy Installation - Solar-Log 200 Installation Manual

Fig.: Display: Device detection completed

26.5.1 Easy Installation (only Solar-Log 1200)

After selecting the language and country, the initial setup can be carried out with the Easy Installation
configuration wizard. Easy Installation can be started for initial setup and carries out the initial set up intui-
tively step by step.
The Easy Installation can also be performed at any time from the
menu on the display.
Easy Installation contains the following configuration steps:
Automatic Device Detection
To do this, the inverters must be connected to the Solar-Log™ and feeding into the grid so that the com-
munication module is working. Please note chapter „34.2 Country specific inverter detection with Easy
Installation" on page 205.
•
Solar-Log™ WEB Internet registration – the device must be connected to a router with the DHCP
service enabled.

Fig.: Display: Start Easy Installation

For more information, please refer to the Quick Start Guide that came with the device.
Direct Device Configurations (Solar-Log 1200 and 2000)
Configuration | Start | Easy Installation
173