Getting Started; Package Contents; Device Connections - CalAmp Vanguard 3000 VG3000-PXS-F User Manual

2

GETTING STARTED

2.1

PACKAGE CONTENTS


Vanguard Router

Power Cable

22 Pin I/O Cable

Mounting bracket

Quick-Start Guide
2.2

DEVICE CONNECTIONS

1. (GSM users) Insert the SIM card into the spring-loaded SIM slot as shown.
Figure 11: Insert SIM card into SIM slot
2. Connect a cellular antenna (for Tx/Rx) to the female SMA connector labeled ANT on the front of the Vanguard
modem. Optionally, a second cellular antenna may be connected to the female SMA connector labeled DIV on
the front panel of the Vanguard modem for Rx diversity.
Note: Use of dual band cellular antennas is preferred.
3. For Mobile units, Connect a GPS antenna to the SMA connector labeled GPS and connect a Wi-Fi antenna to
the RP-SMA connector labeled AUX.
4. Connect an Ethernet cable into either LAN port and plug the other end into the network port of your PC.
5. Connect the DC power cable (or optional AC power adapter) to an applicable power source and plug the
connector into the modem power (PWR) connector. If using the fused power cable to connect to a DC supply
(car battery), use the diagram in Figure 9: Wiring for Ignition sense and accompanying pin-out information in
Table 7 to connect the unit.
Vanguard 3000 Multicarrier Cellular Data Modem & IP Router PN 134732-VG3000 Rev. D| Page 12