CalAmp Vanguard 3000 VG3000-PXS-F User Manual page 98


VPN Server IP Address (Remote ID)

Remote Subnet

Phase1 Encryption

Phase 2 Encryption details

Pre-Shared Key (PSK)

Perfect Forward Security (PFS)

Dead Peer Detection
The objective in this example is to create two IPsec tunnels with the above parameters. These tunnels and the
parameters used to define them will appear the Tunnel Table at the bottom of the Security » IPsec tab as shown in the
figure below. Once these IPsec tunnels have been defined and added to the table, they must be enabled to be
functional.
Figure 62: Tunnel Table using example values
Vanguard IPsec Client Configuration
Step 1 From the laptop connected to the LAN port of the Vanguard 3000, ping the remote IP Address. The pings
should receive replies.
Step 2 Open a Web browser on the connected laptop and navigate to the Vanguard Web interface.
Step 3 From the main navigation pane, select Security, and from the Security page, select the IPsec tab.
10.168.86.192
192.32.8.254/32
3DES/MD5/Group2
3DES/MD5
Password1!
Disabled
delay 30
timeout 150
action Clear
Vanguard 3000 Multicarrier Cellular Data Modem & IP Router PN 134732-VG3000 Rev. D| Page 91
10.168.86.192
10.0.198.198/32
3DES/MD5/Group2
3DES/MD5
Secret2!
Disabled
30
150
Clear