Reset Button - CalAmp Vanguard 3000 VG3000-PXS-F User Manual

Table 8 provides the serial cable design information to integrate the Vanguard modem into your system. Table 9 gives
the default RS-232 / RS-485 communication parameters.
Table 8: Standard RS-232/RS-485 DE-9 Pinout
Pin RS-232 RS-485
Signal Signal
1 DCD --
2 RXD RXP
3 TXD TXP
4 DTR --
5 GND --
6 DSR --
7 RTS TXN
8 CTS RXN
9 RI* 5V
*Always asserted
Table 9 Default RS-232 / RS-485 Communications
Parameters
Parameter Value
Bits Per Second 115,200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None

1.10 RESET BUTTON

The RESET button can be used to return the Vanguard to its factory default settings. Power-on the unit then promptly
press-and-hold the RESET button. The LEDS will cycle through all red, all off, all amber, all green. During the all green
phase, the RSSI LED will turn red to show that the configuration is being reset to defaults. Once the LEDs flash all green
3 times, release the RESET button and proceed as normal.
Direction
← (Out)
←(Out)
→(In)
→(In)
←(Out)
→(In)
← (Out)
←(Out)
Figure 10: DE-9 Connectors
Vanguard 3000 Multicarrier Cellular Data Modem & IP Router PN 134732-VG3000 Rev. D| Page 11
1 5 5 1
6 9 9 6
Male Female