Digital Output - CalAmp Vanguard 3000 VG3000-PXS-F User Manual

NMEA Connection

Manager IP Address/Port
The IP address and service port of the NMEA server (manager).

Manager Connection Type
The connection protocol to communicate with the NMEA server (manager).
NMEA Identification

Unit ID
The Unit Name to be included in the NMEA message payload.

Source Identification
The Unit's IP address that will be included in the NMEA message payload.

Source Port
This is the port from which the NMEA message payload is transmitted.
SMS Notification
Destination Enable/Disable
The SMS notifications to the destinations can be enabled or disabled using the Radio buttons.

Destination 1 / Destination 2 / Destination 3
Alarms and notifications can be sent to up to three SMS destination addresses. Destination addresses are
typically numeric digits only including the country code prefix. The radio buttons above each destination
address can be used to enable or disable each address entered in the adjacent field. The report will consist of
the Unit ID and colon (:) if the Unit ID is not blank, and the appropriate label from the I/O Settings > Labels tab.

Digital Output


Digital Output 1-7
Open or Close (Ground) the particular digital output.
Triggers – Device

Cell Temperature and thresholds
Enable or disable NMEA alarm and notification when temperature goes out of range.
Analog Input

Analog Input and thresholds (1 or 2)
Enable or disable NMEA alarm and notification when an analog input goes out of range.
Vanguard 3000 Multicarrier Cellular Data Modem & IP Router PN 134732-VG3000 Rev. D| Page 77