CalAmp Vanguard 3000 VG3000-PXS-F User Manual page 52

Select the Static Routes tab to open the routing configuration page. Static route tables may be created in this page and
appear at the bottom. Static Routing refers to a manual method used to set up routing between networks.
Figure 34: Router — Static Routes
Static Routes

Route Name
Sets an identifying name for the entry in the Static Route table.

Destination IP Address
Sets the IP address of the destination network.

IP Subnet Mask
Sets the subnet mask of the destination network.

Next Hop
Identifies how packets should be forwarded to reach the destination network. If the destination network is
reachable via LAN, WLAN or PPTP tunnel, a Gateway IP address must be specified. If reachable via cell
interface (WAN) or a PPTP client tunnel, the gateway IP address does not need to be specified.

Metric
Enter a number from 1 to 20. The lower the metric value the higher the route priority.
Click Add to add the configured route to the Routing Table.
Vanguard 3000 Multicarrier Cellular Data Modem & IP Router PN 134732-VG3000 Rev. D| Page 45