Getting Started - CalAmp Dataradio Sentry 4G 900 User Manual

4. GETTING STARTED

4.1 Package Contents
Sentry 4G router

Quick Start Guide

Power cable

User Manual and Quick Start Guide on CD

Mounting Screws

4.2 Setup Requirements
Sentry 4G router

Computer running any operating system with a web browser installed such as Microsoft

Internet Explorer version 6.0 or later or Firefox version 2.0 or later.
10-30V 5-A power supply

Ethernet cable*

Two antennas with male TNC connector* (915 MHz 50-Ohm)

GPS Antenna (SMA Male) *

Two WiFi Antennas (RP-SMA Plug) * ( if applicable)

*These accessories are available from CalAmp.
4.3 Quick Start
Hardware Setup
4.3.1
1. Connect the two Transmit/Receive antennas to the TRX TNC connectors on the front of the
unit. Connect the GPS antenna to the GPS connector. For units utilizing WiFi, connect the WiFi
antennas to the WiFi connectors.
2. Connect an Ethernet cable from the ETH0 connector of the Sentry 4G unit to the PC. If
multiple PCs are being used, connect the Sentry 4G unit to an Ethernet switch or hub
connected to the PCs.
3. Connect a power supply cable to the PWR connector of the Sentry 4G unit. Do not power the
unit on yet.
001-9193-001 Version 1
Figure 4 - Sentry 4G router setup equipment
Page 14 of 48
GETTING STARTED
Sentry 4G 900 TM User Manual