Switch On Trc/Mcrc G41/G42 - HEIDENHAIN CNC PILOT 640 User Manual

DIN/ISO programming | Tool-tip and cutter radius compensation

Switch on TRC/MCRC G41/G42

G41 and G42 switch on the
G41: compensation of the tool-tip/cutter radius to the
contour in traverse direction
G42: compensation of the tool-tip/cutter radius to the
the contour in traverse direction
Parameters:
Q: Level (default: 0)
0: TRC on the turning plane (XZ plane)
1: MCRC on the front face (XC plane)
2: MCRC on the lateral surface (ZC plane)
3: MCRC on the front face (XY plane)
4: MCRC on the lateral surface (YZ plane)
H: Out (only with TRC – default: 0)
0: Intersecting areas which are programmed in directly
successive contour elements are not machined
1: The complete contour is machined—even if certain areas
are intersecting
O: Feed reduc. off (default: 0)
0: No
1: Yes
Please note:
Program G41/G42 in a separate NC block
Program a straight line segment (G0/G1) after the block
containing G41/G42
The is taken into account from the next path of
TRC/MCRC
traverse.
Example: G40, G41, G42
. . .
N1 T3 G95 F0.25 G96 S200 M3
N2 G0 X0 Z2
N3 G42
N4 G1 Z0
N5 G1 X20 B-0.5
N6 G1 Z-12
N7 G1 Z-24 A20
N8 G1 X48 B6
N9 G1 Z-52 B8
N10 G1 X80 B4 E0.08
N11 G1 Z-60
N12 G1 X82 G4
. . .
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
TRC and MCRC.
left of the
of
right
TRC on, to the right of the contour
TRC off
4
303