4.26 Milling Cycles; Overview Of Milling Cycles - HEIDENHAIN CNC PILOT 640 User Manual

4

4.26 Milling cycles

Overview of milling cycles

G791 Linear slot, face. The position and length of the slot are
defined directly in the cycle; slot width = cutter diameter
Further information:
G792 Linear slot, surf.. The position and length of the slot are
defined directly in the cycle; slot width = cutter diameter
Further information:
G793 Contour milling cycle, face. The contour is described
directly after the cycle and concluded by G80 (compatibility cycle
MANUALplus 4110)
Further information:
face G793", Page 408
G794 Contour milling cycle, lateral. The contour is described
directly after the cycle and concluded by G80 (compatibility cycle
MANUALplus 4110)
Further information:
surface G794", Page 410
G797 Area milling. Mills figures (circles, polygons, individual
surfaces, contours) as islands on the face
Further information:
Page 413
G798 Hel. slot milling. Mills a helical slot on the lateral surface,
slot width = cutter diameter
Further information:
G840 Contour milling. Mills ICP contours and figures. Closed
contours are machined inside/outside of the contour, or on the
contour. Open contours are machined from the left/right of the
contour, or on the contour. G840 is used on the face and lateral
surface
Further information:
G845 Pocket milling - roughing. Roughs out closed ICP contours
and figures on the face and lateral surface
Further information:
Page 425
G846 Pocket milling - finishing. Finishes out closed ICP contours
and figures on the face and lateral surface
Further information:
404
"Linear slot, front face G791", Page 406
"Linear slot, lat. surface G792", Page 407
"Contour and figure milling cycle on front
"Contour and figure milling cycle on lateral
"Area milling on front face G797",
"Helical slot milling G798", Page 415
"Mill. contour G840", Page 416
"Pocket milling - roughing G845",
"Linear slot, front face G791", Page 406
DIN/ISO programming | Milling cycles
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017