smart.Turn units | Units – milling, lateral surface (C axis)
Circular slot pattern, lateral surface unit
The unit machines a circular slot pattern in which the individual
features are arranged at a regular spacing on the lateral surface.
The Start point of the slots correspond to the pattern positions.
You define the Slot length and the
unit. The slot width equals the diameter of the milling cutter.
Unit name: G792_Cir_Mant_C / cycle: G792
Further information:
"Linear slot, lat. surface G792", Page 407
Pattern form:
Q: Number of slots
ZM: Center of pattern
CM: Angle of pattern center
A: Start angle
Wi: End angle – Angle increment
K: Pattern diameter
W: Final angle
V: Rotation dir. (default: 0)
V = 0, without W: Figures are arranged on a full circle
V = 0, with W: Figures are arranged on the longer circular arc
V = 0, with Wi: The algebraic sign of Wi defines the direction
(Wi < 0: clockwise)
V = 1, with W: Clockwise
V = 1, with Wi: Clockwise (algebraic sign of Wi has no effect)
V = 2, with W: Counterclockwise
V = 2, with Wi: Counterclockwise (algebraic sign of Wi has
no effect)
Cycle form:
X1: Upper edge of milling
X2: Milling floor
L: Slot length
A1: Angle to Z axis (default: 0°)
P: Maximum infeed
FZ: Approach feed (default: active feed rate)
Further forms:
Further information:
"smart.Turn unit", Page 78
Access to the technology database:
Machining operation: milling
Affected parameters: F, S, FZ, P
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
in the
position of the slots
2
185