Index - HEIDENHAIN CNC PILOT 640 User Manual

4
Example: G71
. . .
N1 T5 G97 S1000 G95 F0.2 M3
N2 G0 X0 Z5
N3 G71 Z-25 A5 V2
. . .
Parameter combinations for single holes without contour
description
XS, XE
XS, K
XE, K
Feed rate reduction:
Indexable insert drill and twist drill with 180° drilling angle
A feed rate reduction is only effective if the parameter Tap/
Drill. lth A has been defined
Other drills
Beginning of hole: Feed rate reduction as programmed in V
End of hole: Reduction as of hole end point—length of first
cut—safety clearance
Length of first cut = tool tip
Set-up clearance
Further information:
Cycle run:
1 Approach behavior:
Hole without contour definition: Tool is located at the starting
point (safety distance from the bore hole)
Hole with contour definition: Tool moves at rapid traverse to
the starting point
RB not programmed: Moves up to the safety clearance
RB programmed: Moves to the position RB and then to
the safety clearance
2 Spot drilling. Feed rate reduction depending on V
3 Drill hole at feed rate.
4 Through drilling. Feed rate reduction depending on V
5 Retraction at rapid traverse or feed rate, depending on D
6 Retraction position:
RB not programmed: Retraction to the starting point
RB programmed: Retraction to the position RB
374
ZS, ZE
ZS, K
ZE, K
"Safety clearance", Page 310
DIN/ISO programming | Drilling cycles
Drilling
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017