See User's Manual - HEIDENHAIN CNC PILOT 640 User Manual

New functions of software 688945-05 and 54843x-05
The control displays the error messages in different colors
depending on the error message class, see User's Manual
If the programmed rotational speed is shown in red in the
machine data display, a limitation is active and the programmed
nominal value will not be reached, see User's Manual
Additional functions, such as handwheel symbol and datum
shift of the C axis, were added to the machine data display,

see User's Manual

In order to restart only the control, the RESTART soft key was
added, see User's Manual
In Teach-in submode, the input range for cycle parameter Angle
in the B axis BW was expanded to four decimal places in the
TSF dialog.
In Teach-in submode and in DIN/ISO programming, the input
range for Thread pitch was expanded to four decimal places.
In Simulation submode, the miscellaneous function Mark the
machining area was added, see User's Manual
In Simulation submode, the miscellaneous function C0 –
Marking on workpiece/3D was added, see User's Manual
A new status display was added in Simulation submode,
see User's Manual
Display of the tool holder is supported in 3-D simulation,
see User's Manual
The variables defined in the PROGRAM HEAD program section
can be displayed in Program run submode, see User's Manual
In Tool editor operating mode, the diagnostic bits displayed can
be edited when the tool dialog is open, see User's Manual
In Tool editor operating mode, the tool parameter Max. shaft
speed NMX was added, see User's Manual
In Tool editor operating mode, the tool parameters Tool radius
2 R2 and Tool radius 2 oversize DR2 were added for standard
milling tools, see User's Manual
In Tool editor operating mode, the tool parameters (calibration
values) CA1 and CA2 were added for 3-D touch probes,
see User's Manual
In Tool editor operating mode, the parameters Halter Tiefe
WHT and Versatz für Tiefe TOF were added to the tool holder
dialogs, see User's Manual
The Delete all soft key was added to the Table of the tool
holder, see User's Manual
The Save and Cancel soft keys were added to the Tool text list,
see User's Manual
The columns LA, XL and ZL are displayed in the Turret
assignment and Magazine list.
The arrow keys enable you to move to the next or previous
column within the Turret assignment and Magazine list.
In order to enable you to transfer screenshots (PRT SC key), the
Select TNC: soft key was added to the Transfer operating mode
in the Service area, see User's Manual
14
Fundamentals | Software and features
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017