4
Linear pattern on front/rear face G401-Geo
G401 defines a linear hole pattern or figure pattern on the front
or rear face. G401 is effective for the hole/figure defined in the
following block (G300..G305, G307).
Parameters:
Q: Number of figures
XK: Start point (Cartesian)
YK: Start point (Cartesian)
I: Final point (Cartesian)
Ii: Final point – distance between two figures (in X)
J: Final point (Cartesian)
Ji: Final point – distance between two figures (in Y)
A: Angle to XK axis (default: 0°)
R: Length – total length of pattern
Ri: Length – Incremental distance
Programming notes:
Program the hole or figure in the following block
without a center
The milling cycle (MACHINING section) calls the
hole/figure in the following block—not the pattern
definition
282
DIN/ISO programming | Front/Rear face contours
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017