4
Polygon on front/rear face G307
G307 defines a polygon in a contour on the front face/rear face.
Program this figure in conjunction with G840, G845 or G846.
Parameters:
XK: Center (Cartesian)
YK: Center (Cartesian)
X: Diameter – Center (polar)
C: Angle – Center (polar)
A: Angle to XK axis (default: 0°)
Q: Number edges
K: +edge lngth/-width a. flats
K > 0: Edge length
K < 0: Width across (Inside diameter)
R: Chamf./round. (default: 0)
R > 0: Radius of rounding arc
R < 0: Chamfer width
P: Depth/Height – depth for pockets, height for islands
P < 0: Pocket
P > 0: Island
Linear slot on lateral surface G311
G311 defines a linear slot in a lateral-surface contour. Program this
figure in conjunction with G840, G845 or G846.
Parameters:
Z: Center
CY: Center as linear value (reference: unrolled Reference
diameter)
C: Center (angle)
A: Angle to Z axis (default: 0°)
K: Length
B: Breadth
P: Depth
342
DIN/ISO programming | Contour definitions in the machining section
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017