Predrilling, Pocket Milling, Icp, Lateral Surface Unit - HEIDENHAIN CNC PILOT 640 User Manual

smart.Turn units | Units – Predrilling in C axis

Predrilling, pocket milling, ICP, lateral surface unit

The unit determines the hole position and machines the hole.
The subsequent milling cycle obtains the hole position from the
reference stored in NF. If the pocket consists of multiple sections,
the unit machines a hole for each section.
Unit name: DRILL_MAN_845_C / cycles: G845 A1; G71
"G845 – calculating hole positions",
Further information:
Page 426
"Simple drilling G71", Page 373
Further information:
Contour form:
FK: ICP contour number
NS: Starting block no. of contour – beginning of contour
section
NE: Contour end block no. – end of contour section
X1: Upper edge of milling (diameter value; default: Starting
point X)
P2: Depth of contour
Cycle form:
JT: Machining direction
0: From the inside out
1: From the outside in
H: Mill cutting direction
0: Up-cut
1: Climb
I: Contour-parallel oversize
K: Infeed-direction oversize
U: Overlap factor – defines the overlap of milling paths (default:
0.5) (range: 0 to 0.99)
Overlap = U * milling diameter
WB: Milling diameter
NF: Position mark – reference at which the cycle stores the
hole positions (range: 1 to 127)
E: Period of dwell at end of hole (default: 0)
D: Retraction type
0: Rapid traverse
1: Feed rate
V: Feed reduction
0: Without reduction
1: At end of the hole
2: At start of the hole
3: At start & end of hole
AB: Drilling lengths (default: 0)
RB: Return plane (default: back to start position)
Further forms:
Further information: "smart.Turn unit", Page 78
Access to the technology database:
Machining operation: Drilling
Affected parameters: F, S
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
2
149