Icp Predrilling, Contour Milling, Yz Plane Unit - HEIDENHAIN CNC PILOT 640 User Manual

3

ICP predrilling, contour milling, YZ plane unit

The unit determines the hole position and machines the hole.
The subsequent milling cycle obtains the hole position from the
reference stored in NF. If the milling contour consists of multiple
sections, the unit machines a hole for each section.
Unit name: DRILL_MAN_840_Y / cycles: G840 A1; G71
Further information:
Page 417
Further information:
Contour form:
FK: ICP contour number
NS: Starting block no. of contour – beginning of contour
section
NE: Contour end block no. – end of contour section
X1: Upper edge of milling
P2: Depth of contour
Cycle form:
JK: Cutter position
0: On the contour
1: Within/left of contour
2: Outside/right of contour
3: Depending on H and MD
H: Mill cutting direction
0: Up-cut
1: Climb
I: Contour-parallel oversize
K: Infeed-direction oversize
R: Approach radius
WB: Milling diameter
NF: Position mark – reference at which the cycle stores the
hole positions (range: 1 to 127)
E: Period of dwell at end of hole (default: 0)
D: Retraction type
0: Rapid traverse
1: Feed rate
V: Feed reduction
0: Without reduction
1: At end of the hole
2: At start of the hole
3: At start & end of hole
AB: Drilling lengths (default: 0)
RB: Return plane (default: back to start position)
Further forms:
Further information:
Access to the technology database:
Machining operation: Drilling
Affected parameters: F, S
214
"G840 – calculating hole positions",
"Simple drilling G71", Page 373
"smart.Turn unit", Page 78
smart.Turn units for the Y axis | Units – Predrilling in Y axis
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017