Linear Pattern In Yz Plane G481-Geo - HEIDENHAIN CNC PILOT 640 User Manual

DIN/ISO Programming for the Y axis | Contours in the YZ plane

Linear pattern in YZ plane G481-Geo

G481 defines a linear pattern in the YZ plane.
G481 affects the hole or figure defined in the following block
(G380-G385, G387).
Parameters:
Q: Number of figures
Z: 1st pattern point
Y: 1st point of pattern
K: Final point of pattern (Z direction)
J: Final point of pattern (Y direction)
Ki: Final point – distance between two figures (in Z)
Ji: Final point – distance between two figures (in Y)
A: Position angle (reference: positive Z axis; default: 0°)
R: Length – total length of pattern
Ri: Length – distance between two figures
Programming notes:
Program the hole or figure in the following block
without a center
The milling cycle (MACHINING section) calls the
hole/figure in the following block—not the pattern
definition
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
6
583