Step-By-Step Instructions - Wipe/Format - Logicube Talon Ultimate User Manual

To perform more than one task at a time (Image, Hash, Wipe/Format),
the Multi-Task Option must be purchased and installed.
Secure Erase – Sends a command to the drive instructing it to wipe the drive based on
•
the hard drive manufacturer's specifications for the Secure Erase command.
Contact the hard drive manufacturer for Secure Erase
specifications for each model/type of hard drive.
Secure erase will not work on drives connected
through the USB or FireWire ports.
Wipe Patterns – Allows the user to set a specific pattern to use for wiping the drive. The
•
number of passes is customizable (up to 7 passes) along with the type of data written for
each pass. In addition, a 7-pass DoD wipe can be set with pre-selected pass values.
Format – Instructs the Talon Ultimate to format a drive (with or without encryption). The
•
Talon Ultimate can format the drive using the following file systems: EXT4, NTFS, exFAT,
FAT32.
For in-depth information regarding drive encryption,
please see
3.3.1 Step-by-step instructions – Wipe/Format
1. Select Wipe from the types of operation on the left side.
2. Tap the Destination icon and select one or more drives then tap the OK
Logicube Talon Ultimate™ User's Manual
Chapter 7: Drive Encryption and
icon.
It is recommended to use the same capacity drives
per task. When smaller capacity drives are wiped
together with larger capacity drives, the smaller
drives will finish first. However, the ports will not
be available until the entire task is finished.
QUICK START
Decryption.
23