Step-By-Step Instructions - Drive Hash Or Case Verify; Wipe/Format - Logicube Talon Ultimate User Manual

3.2.1 Step-by-step instructions – Drive Hash or Case Verify
1. Select Hash from the types of operation on the left side.
2. Tap the Modes icon and select the desired mode (Drive Hash or Case
3. Tap the Drives icon and select the drive(s) to be hashed then tap the OK
4. Tap the Settings icon to choose the different settings based on the
5. Change any of the optional settings (LBA settings or percentage of the
6. Optional: Tap Case Info to set the Case/File Name, Case ID, Examiner,
7. When finished, the status will show "COMPLETED". At this point, it is

3.3 Wipe/Format

Destination drives can be wiped and formatted using the Talon Ultimate. The
Destination drive must be formatted to have a valid file system, so it can be
used as a Destination drive when using the Drive to File or File to File modes of
imaging. The following methods are available in the Wipe menu:
Details on the different screens found in the Wipe/Format
operation can be found in
Logicube Talon Ultimate™ User's Manual
Verify).
icon.
Mode. Details for every setting can be found in
drive to be hashed) if needed.
Evidence ID, or Case Notes.
recommended to tap Reset Task to reset the task, so the drive bays
properly reset and not show as being used or assigned for other tasks.
Section 5.3:
Section
Wipe/Format.
QUICK START
5.2.3.
22