Logicube Talon Ultimate User Manual page 134

8. The Image file should now be seen in the Win32 Disk Imager screen under 'Image File'.
9. Under 'Device', select the drive letter for the USB flash drive that was connected during
step 4 then click the Write icon.
10. A confirmation screen will appear. Make sure that the "Target Device" is set to the correct
drive letter. If it is the correct drive letter, click Yes to continue. If it is showing the wrong
drive letter, click No. This will take you back to the previous screen where you can select
the correct drive letter (back to step 9).
11. The USB flash drive is now being prepared and the progress bar should be advancing.
Logicube Talon Ultimate™ User's Manual
USB BOOT CLIENT
125