From Usb Drive (Through A Software File Download) - Logicube Talon Ultimate User Manual

4. Tap the Update icon to begin the update. The unit should begin the
5. Turn the unit off. Wait at least 5 seconds then turn the unit back on.
6.

8.1.2 From USB Drive (Through a software file download)

Aside from the network option, the latest software can also be downloaded from
Logicube's website and be placed onto a USB flash drive to perform the
update/re-install. It is recommended to use an empty USB flash drive.
1. Download the latest software from the product support page at
2. Extract the contents of the downloaded zip file to the root of the USB
3. Turn the unit on. When the main software screen appears, connect the
4. From the main menu on the unit, locate and tap the Software Updates
5. Select From USB Drive. The unit then check for the version of the
6. Tap the Update icon to begin the update. The unit should begin the
7. Turn the unit off. Wait at least 5 seconds then turn the unit back on.
Logicube Talon Ultimate™ User's Manual
UPDATING THE TALON ULTIMATE SOFTWARE
If this message is seen, make sure the unit is connected to a
network with internet access and try step 3 again or try updating
the software from a USB drive.
update process. Do not interrupt the update process. It may take several
minutes. Once completed, a screen will appear stating the update is
complete and will prompt you to turn the unit off then back on.
Verify the software version is correct by going to the Software Updates
screen.
https://www.logicube.com/knowledge/talon-ultimate.
flash drive.
USB flash drive (that has the extracted software from step 2) to the
USB_S1 port (the USB port on the left side).
icon on the left side.
software on the USB drive. After a few seconds, one of the following
messages should appear:
Software found – A software version is found on the USB flash
•
drive. Tap the OK icon to continue.
No new version found – The unit did not find any software on
•
the USB flash drive. Double-check that the correct software was
downloaded and that the files were extracted to the root of the
USB flash drives (steps 1 and 2). Tap the OK icon to continue and
try step 5 again or try updating the software using the "From
Network" option.
update process. Do not interrupt the update process. It may take several
minutes. Once completed, a screen will appear stating the update is
complete and will prompt you to turn the unit off then back on.
108