Step-By-Step Instructions - Imaging - Logicube Talon Ultimate User Manual

The File to File Imaging mode requires the Targeted Imaging Option
purchased and installed.
To perform more than one task at a time (Image, Hash, Wipe/Format),
the Multi-Task Option must be purchased and installed.
DD, E01, EX01, and DMG files created on the Destination may
be smaller than the selected Segment size. For example, if 4GB
segment size selected, some files may be less than 4GB. This
occurs when there is a lot of blank space on the Source drive.
Talon Ultimate uses a concurrent Image+Verify process. When Verify is set, the Talon Ultimate
images and verifies concurrently and takes advantage of destination hard drives that may be
faster than the source hard drive. Duration of the total image process time may be reduced by up
to half.
The Talon Ultimate imaging, hash, and wipe speeds are determined
by several factors including the following:
The manufacturer specifications of the drive(s) being used
-
The age of the drive (manufactured date)
-
How often that drive has been used
-
For example, a 2 TB drive with 64MB of cache produced by the
manufacturer 2 years ago is most likely slower than a 2 TB drive
that the same manufacturer just released this year, even though
they are both 7200RPM with 64MB of cache, and both are SATA III.
3.1.1 Step-by-step instructions – Imaging
1. Select Imaging from the types of operation on the left side.
2. Tap the Mode icon and select Drive to Drive or Drive to File then tap
Logicube Talon Ultimate™ User's Manual
the OK icon.
QUICK START
17