Decrypting The Drive Without A Talon Ultimate - Logicube Talon Ultimate User Manual

7. Choose the drive to be viewed then tap the ENGAGE icon. The 'DRIVE
8. Connect a micro-B USB 3 cable (A to micro-B) between the computer and
9. After a few moments, Windows should assign a drive letter to the
10. When finished, tap the DISENGAGE icon to disengage the USB mode.

7.3 Decrypting the drive without a Talon Ultimate

To mount and read an encrypted Destination drive in Windows, without using a Talon Ultimate,
Logicube recommends one of three third-party utilities called VeraCrypt, TrueCrypt or
FreeOTFE. Other utilities may work but are not supported or tested by Logicube.
Logicube cannot offer support for third-party utilities. Please
contact the software's manufacturer for support, if needed.
Logicube Talon Ultimate™ User's Manual
STATUS' for the selected drive will change to "ENGAGED" and the
ENGAGE icon will change to DISENGAGE. At this point, connect a USB
cable between the computer and the Talon Ultimate.
the Talon Ultimate. Connect the micro-B connector to the Talon
Ultimate's USB Device Port located on the front panel of the Talon
Ultimate. Connect the USB A connector to an available USB port on the
computer.
selected drive. The contents of the drive should now be accessible in
Windows.
The USB cable can now be disconnected from the computer and the
Talon Ultimate.
If the data on the drive is unrecognizable,
disconnect the drive from the Talon Ultimate,
then double-check the encryption settings
(steps 2 through 4), then re-connect the drive.
DRIVE ENCRYPTION & DECRYPTION
97