Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual page 790

Configuring Access Guardian
4
Configure any switch port that will connect to a Stellar AP device as a UNP bridge port. For example:
-> unp port 1/1/12 port-type bridge
5
If necessary, enable the UNP AP mode for the switch (this mode is enabled by default). For example:
-> unp ap-mode enable
6
Enable MVRP for the switch to facilitate the propagation of the AP management VLAN and AP client
VLANs. For example:
-> mvrp enable
7
Optionally disable authentication on the UNP port if authentication of the AP device is not required.
For example:
-> no unp port 1/1/12 802.1x-authentication
-> no unp port 1/1/12 mac-authentication
8
Optionally configure the QoS policy list, authentication flag status, or mobile tag status for the
defaultWLANProfile (changing other parameter values for this profile is not supported). For example:
-> unp profile defaultWLANProfile qos-policy-list qlist1
-> unp profile defaultWLANProfile authentication-flag
-> unp profile defaultWLANProfile inactivity-interval 200
ERROR: defaultWLANProfile parameters cannot be modified. Mobile-Tag, Qos-policy-
list, Authentication are only allowed
9
Optionally configure the system name, system location, and port alias. The information from one or
more of these settings is used to derive the AP Location information that is transmitted by the switch to
the connected AP device.
-> system name BWIAPS01
-> system location BWI Airport Hotel
-> interfaces port 1/1/12 alias BWI-AP01
Verify the OmniSwitch Configuration
1
Use the show vlan
created to carry AP client-tagged traffic. Note that "UNP-DYN-VLAN" identifies VLANs dynamically
created for AP client traffic. For example:
-> show vlan
vlan type
------+-------+-------+------+------+------+------------------
1 std
11 std
200 std
500 unpd
501 unpd
2
Use the show vlan members
For example:
-> show vlan 200 members
port type
----------+-----------+---------------
1/1/20 qtagged
1/1/24 qtagged
OmniSwitch AOS Release 8 Network Configuration Guide
command to display the VLAN created for AP management and other VLANs
admin oper ip
Ena Ena Ena
Ena Dis Dis
Ena Dis Ena
Ena Dis Dis
Ena Dis Dis
command to verify the port assignments for the AP management VLAN.
status
inactive
inactive
mtu name
1500 VLAN 1
1500 VLAN 11-AP Client
1500 AP Management VLAN
1500 UNP-DYN-VLAN
1500 UNP-DYN-VLAN
December 2017
OmniAccess Stellar AP Integration
page 28-73