Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual page 773

Configuring Access Guardian
-> show vlan 450
Name
Type
Administrative State
Operational State
IP Router Port
IP MTU
•
Dynamic VLANs are not saved in the "! VLAN:" section of the switch configuration file (boot.cfg).
However, the unp commands to enable dynamic VLAN configuration and create the UNP are saved in
the "! DA-UNP:" section of boot.cfg (see the following sample boot.cfg file). As a result, the VLAN is
created again on the next switch bootup.
-> show configuration snapshot vlan
! VLAN:
vlan 1 admin-state enable
vlan 451 admin-state enable
vlan 777 admin-state enable
vlan 887-888 admin-state enable
-> show configuration snapshot da
! DA-UNP:
unp dynamic-vlan-configuration enable
unp profile "temp1"
unp profile "unpTemp"
unp profile "unpTemp2"
unp profile "temp1" map vlan 450
unp profile "unpTemp" map vlan 10
unp profile "unpTemp2" map vlan 10
unp classification mac-address 00:00:00:00:00:01 profile1 unpTemp2
unp classification mac-address 10:22:33:44:55:66 profile1 unpTemp2
unp classification ip-address 1.1.1.2 mask 255.0.0.0 profile1 unpTemp2
unp port 1/1/11 port-type bridge
unp port 1/1/11 802.1x-authentication
unp port 1/1/11 classification
unp port 1/1/12 port-type bridge
unp port 1/1/12 mac-authentication
unp port 1/1/12 classification
To verify the status of dynamic VLAN configuration for the switch, use the
configuration command. For example:
-> show unp global configuration
Dynamic Vlan Configuration
Dynamic Profile Configuration
Auth Server Down Profile1
Auth Server Down Profile2
Auth Server Down Profile3
Auth Server Down Timeout
Redirect Port Bounce
Redirect Pause Timer
Redirect http proxy-port
Redirect Server IP
Allowed IP
Force L3-Learning
Force L3-Learning Port Bounce
802.1x Pass Through Mode
AP Mode
OmniSwitch AOS Release 8 Network Configuration Guide
: UNP-DYN-VLAN,
: UNP Dynamic Vlan,
: enabled,
: disabled,
: disabled,
: 1500
= Enabled,
= Disabled,
= -,
= -,
= -,
= 60,
= Enabled,
= -
= 8080
= 10.1.1.1
= -
= Disabled
= Disabled
= Disabled
= Enabled
December 2017
Configuring Port-Based Network Access Control
show unp global
page 28-56