Quick Steps For Creating A Virtual Router - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring VRRP

Quick Steps for Creating a Virtual Router

1
Create a virtual router. Specify a virtual router ID (VRID) and an existing VLAN ID. For example:
-> vrrp 6 4
Specify a VLAN that is configured with an IP interface. For information about creating VLANs, see
Chapter 4, "Configuring VLANs."
2
Configure an IP address for the virtual router.
-> vrrp 6 4 address 10.10.2.3
Note. Optionally, the ip parameter can be used instead of the address parameter in the above example.
3
Repeat steps 1 through 2 on all of the physical switches that will participate in backing up the
address(es) associated with the virtual router.
4
Enable VRRP on each switch.
-> vrrp 6 4 admin-state enable
Note. Optional. To verify the VRRP configuration, enter the
similar to the one shown here:
-> show vrrp
VRRP default advertisement interval: 5 seconds
VRRP default priority: 100
VRRP default preempt: Yes
VRRP trap generation: Enabled
VRRP startup delay: 45
VRRP BFD-STATUS : Disabled
VRID VLAN Address(es)
----+----+---------------+--------+--------+------+----------
6 4 10.10.2.3
For more information about this display, see the OmniSwitch AOS Release 8 CLI Reference Guide.
OmniSwitch AOS Release 8 Network Configuration Guide
(expired)
IP Admin
Status
Enabled
Quick Steps for Creating a Virtual Router
show vrrp|vrrp3
Adv.
Priority Preempt Interval
100 yes 1
December 2017
command.The display is
page 23-3