Removing Ports From A Static Aggregate Group - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Static Link Aggregation
the linkagg static port agg
(/), the port number, agg, and the number or ID of the static aggregate group.
For example, to assign ports 1, 2, and 3 in slot 1 to static aggregate group 10 (which has a size of
-> linkagg static port 1/1-3 agg 10
-> linkagg static port 1/2 agg 10
-> linkagg static port 1/3 agg 10
Note. A port belongs to only one aggregate group.
For example, to assign port 1 in slot 1 to static aggregate group 10, enter:
-> linkagg static port 1/1 agg 10

Removing Ports from a Static Aggregate Group

To remove a port from a static aggregate group you use the no form of the
command by entering no linkagg static port followed by the slot number, a slash (/), and the port
number. For example, to remove port 4 in slot 1 from a static aggregate group, enter:
-> no linkagg static port 1/4
Ports must be deleted in the reverse order in which they were assigned. For example, if port 9 through 16
were assigned to static aggregate group 2 you must first delete port 16, then port 15, and so forth. The
following is an example of how to delete ports in the proper sequence from the console:
-> no linkagg static port 1/24
-> no linkagg static port 1/23
-> no linkagg static port 1/22
OmniSwitch AOS Release 8 Network Configuration Guide
command by entering linkagg static port followed by the slot number, a slash
Configuring Static Link Aggregation Groups
linkagg static port agg
December 2017
4), enter:
page 8-8