Quick Steps For Configuring Saa - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Service Assurance Agent

Quick Steps for Configuring SAA

The following steps provide a quick tutorial on how to configure SAA. Each step describes a specific
operation and provides the CLI command syntax for performing that operation.
Creating SAA:
1
Create the base SAAs using the
-> saa saa1 description "saa for ip-ping" interval 120 rtt-threshold 20000
-> saa saa2 description "saa for mac-ping" interval 500 jitter-threshold 10000
-> saa saa3 description "saa for eth-lb" interval 160
-> saa saa4 description "saa for eth-dmm" interval 300
2
Configure SAA "saa1" for IP ping using the
-> saa saa1 type ip-ping destination-ip 123.22.45.66 source-ip 123.35.42.125
type-of-service 5 inter-pkt-delay 1500 num-pkts 8 payload-size 1000
3
Configure SAA "saa2" for MAC ping using the
-> saa saa2 type mac-ping destination-macaddress 00:11:11:11:11:11 vlan 10 vlan-
priority 3
4
Configure SAA saa3 for Ethoam loopback using the
example:
-> saa saa3 type ethoam-loopback target-endpoint 10 source endpoint 2 domain md1
association ma1 vlan-priority 5 drop-eligible true inter-pkt-delay 500
5
Configure SAA "saa4" for ETH-DMM using
example:
-> saa saa4 type ethoam-two-way-delay target-endpoint 5 source endpoint 1 domain
md2 association ma2 vlan-priority 4 inter-pkt-delay 1000
6
Start the SAA using the
-> saa saa1 start
-> saa saa2 start at 2009-10-13,09:00:00.0
7
Stop the SAA using the
-> saa saa1 stop
-> saa saa2 stop at 2009-10-13,10:00:00.0
OmniSwitch AOS Release 8 Network Configuration Guide
saa command. For example:
saa type ip-ping
saa type mac-ping
saa type ethoam-two-way-delay
saa start command.
saa stop command.
Quick Steps for Configuring SAA
command. For example:
command. For example:
saa type ethoam-loopback
December 2017
command. For
command. For
page 38-3