Configuring Qos Policy Lists - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Access Guardian
-> unp vxlan far-end-ip-list vteps 10.1.1.1 20.1.1.1 30.1.1.1 40.1.1.1
To verify the VXLAN far-end IP address list configuration, use the
command. For example:
-> show unp vxlan far-end-ip-list toDataCenter2
Far-End-Ip-List Name: vteps, IP-Count: 4,
IP-Addresses:
10.1.1.1
20.1.1.1
30.1.1.1
40.1.1.1
To verify the VXLAN service profile configuration for the switch, use the
command with the service-type vxlan parameter. For example:
-> show unp profile map service-type vxlan
Profile
Name
-----------------------------+-----+-----+------------+-------+-------+---------
vmCluster1
vmCluster2
Mapping a Static Service to a UNP Profile
To configure the mapping of an existing SPB or VXLAN service to an existing UNP profile, use the
profile map service-type static
service mapping for the "vNP2" profile that will carry traffic tagged with VLAN 5 on the existing SAP
that is associated with service ID 10:
-> unp profile unp1-staticSPB map service-type static tag-value 20 service-id 10
To verify the static service profile configuration for the switch, use the
with the service-type static parameter. For example:
-> show unp profile map service-type static
Profile
Name
--------------------------------+--------+--------
unp1-staticSPB
unp2-staticVXLAN
Total Profile Static-Service-Map Count: 2

Configuring QoS Policy Lists

One of the attributes for UNP profiles specifies the name of a list of QoS policy rules. This list is applied
to a user device when the device is initially assigned to the profile. Using policy lists allows the
administrator to associate a group of users to a set of QoS policy rules. The policy rules applied determine
the initial role (network access) for a user device classified into the profile.
To create a QoS policy list to assign to a UNP profile, use the
and then use the policy list rules
rules to add to the list. For example, the following commands create two policy rules and associates these
rules with the "temp-rules" list:
-> policy condition c1 802.1p 5
-> policy action a1 disposition drop
OmniSwitch AOS Release 8 Network Configuration Guide
Tag Far-End-List Vlan
Vnid Value
2300 12 -
2301 15 vteps
command. For example, the following command configures a static
Tag
SvcId Value
10 20
20 40:50
command to specify the names of one or more existing QoS/ACL policy
December 2017
Configuring Port-Based Network Access Control
show unp vxlan far-end-ip-list
show unp profile map
Mcast
Xlation Mode
Ena Tandem
Ena Headend -
show unp profile map
policy list command to specify a list name
Mcast
Group
225.1.1.1
unp
command
page 28-61