Using Guest Tunneling - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Omniswitch aos release 8
Table of Contents

Advertisement

Configuring Access Guardian

Using Guest Tunneling

Guest Tunneling is a mechanism that is used to identify and isolate guest traffic from the rest of the
internal network traffic. The tunneling protocol used is Layer 2 Generic Routing Encapsulation (GRE). A
GRE tunnel is defined by configuring one end of the tunnel on an edge (access) switch and the other end
of the tunnel on a Guest Tunnel Termination Switch (GTTS).
Traffic received on the edge switch is classified into a UNP guest profile that is mapped to a Layer 2
GRE tunnel. The guest traffic is then encapsulated and tunneled through the network to the GTTS.
When the tunneled traffic reaches the GTTS, the GRE encapsulation is removed and the traffic is then
forwarded through a physical loopback port to a VLAN domain. At this point, the guest traffic can gain
access to a perimeter network and/or the Internet.
There are two scenarios in which guest traffic is identified and isolated:
Device traffic received on a UNP bridge port is classified directly into a UNP Guest profile that is
assigned as the default profile for the UNP port. This occurs when Layer 2 authentication or
classification does not return a UNP assignment for the device. The UNP Guest profile is mapped to a
Layer 2 GRE tunnel through which the device traffic is tunneled to the GTTS.
Device traffic received on a UNP bridge port is initially classified into a UNP VLAN profile.
Secondary authentication (such as Captive Portal or BYOD) then assigns the device traffic to the UNP
Guest profile that is mapped to a Layer 2 GRE tunnel through which the device traffic is tunneled to
the GTTS.
This section provides the following information regarding configuring and using the OmniSwitch Guest
Tunneling mechanism:
"Configuration Overview and Guidelines" on page
"Quick Steps for Configuring Guest Tunneling" on page
"Guest Tunneling Configuration Example" on page
OmniSwitch AOS Release 8 Network Configuration Guide
28-84.
28-88.
28-90.
December 2017
Using Guest Tunneling
page 28-83

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents