Ethernet Oam Defaults - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Ethernet OAM

Ethernet OAM Defaults

The following table shows Ethernet OAM default values.
Parameter Description
MHF value assigned to a MD
ID-permission value for MD entry
MHF value assigned to a MA
Continuity Check Message interval
for the MA
Default domain level
Default domain MHF value
Default domain ID permission
The administrative status of the MEP
The priority value for CCMs and
LTMs transmitted by the MEP
The lowest priority fault alarm for
the lowest priority defect for a MEP
Number of Loopback messages
Fault notification generation reset
time
OmniSwitch AOS Release 8 Network Configuration Guide
Command
ethoam domain mhf
ethoam domain id-permission
ethoam association mhf
ethoam association ccm-
interval
ethoam default-domain level
ethoam default-domain mhf
ethoam default-domain id-
permission
ethoam endpoint admin-state
ethoam endpoint priority
ethoam endpoint lowest-
priority-defect
ethoam loopback
ethoam fault-reset-time
December 2017
Ethernet OAM Defaults
Default Value/Comments
none
none
defer
10 seconds
0
none
none
disable
7
mac-rem-err-xcon
1
1000 centiseconds
page 37-2