Modifying The Actor Port System Priority - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring Dynamic Link Aggregation
Configuring an Actor Port System ID
You can configure the actor port system ID by entering linkagg lacp port, the slot number, a slash (/), the
port number, actor system-id, and the user specified actor port system ID ( MAC address) in the
hexadecimal format of xx:xx:xx:xx:xx:xx.
For example, to modify the system ID of the dynamic aggregate actor port 3 in slot 7 to
00:20:da:06:ba:d3, enter:
-> linkagg lacp port 7/3 actor system-id 00:20:da:06:ba:d3
For example, to modify the system ID of the dynamic aggregate actor port 3 in slot 7 to
00:20:da:06:ba:d3 and document that the port is 10 Mbps Ethernet you would enter:
-> linkagg lacp port 7/3 actor system-id 00:20:da:06:ba:d3
Restoring the Actor Port System ID
To remove a user-configured system ID from a dynamic aggregate group actor port configuration, use the
no form of the linkagg lacp port actor system-id
number, a slash (/), the port number, and actor system-id keyword.
For example, to remove a user-configured system ID from dynamic aggregate actor port 3 in slot 7, enter:
-> linkagg lacp port 7/3 actor system-id

Modifying the Actor Port System Priority

By default, the actor system priority is 0. The following subsections describe how to configure a user-
specified value and how to restore the value to its default value with the
priority command.
Configuring an Actor Port System Priority
You can configure the actor system priority to a value by entering lacp agg, the slot number, a slash (/),
the port number, actor system priority, and the user-specified actor port system priority.
For example, to modify the system priority of dynamic aggregate actor port 5 in slot 2 to 200 you would
enter:
-> linkagg lacp port 2/5 actor system-priority 200
For example, to modify the system priority of dynamic aggregate actor port 5 in slot 2 to 200, enter:
-> linkagg lacp port 2/5 actor system-priority 200
Restoring the Actor Port System Priority
To remove a user-configured actor port system priority from a dynamic aggregate group actor port
configuration use the no form of the
linkagg lacp agg, the slot number, a slash (/), the port number, and actor system priority.
For example, to remove a user-configured system priority from dynamic aggregate actor port 5 in slot 2
you would enter:
-> no linkagg lacp port 2/5 actor system-priority
OmniSwitch AOS Release 8 Network Configuration Guide
Modifying Dynamic Link Aggregate Group Parameters
command by entering no linkagg lacp agg, the slot
linkagg lacp port actor system-priority
December 2017
linkagg lacp port actor system-
command by entering no
page 9-18