Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual page 855

Configuring Access Guardian
2
Configure the mode of operation for the switch. For gateway mode, set the mode to gateway. To
configure the mode, use the
-> zeroconf mode gateway
3
Configure the gateway VLAN list. Traffic from the edge switches will be forwarded at L2 to the
gateway switch. From the gateway switch, the mDNS and SSDP packets will be relayed to other VLANs
based on the gateway VLAN list configured. To configure the gateway VLAN list, use the
gateway-vlan-list command. For example:
-> zeroconf gateway-vlan-list 1 4 6
Note. Maximum of 10 gateway VLANs is supported in a list.
If the network consists of an OmniSwitch controller as responder (Tunnel Standard mode), the
following must be configured on the edge switch:
1
Enable mDNS and SSDP functionality using the
admin-state command.
To enable mDNS relay on the switch, enter:
-> zeroconf mdns admin-state enable
To enable SSDP relay on the switch, enter:
-> zeroconf ssdp admin-state enable
2
Configure the mode of operation for the switch. Set the mode to tunnel type standard. To configure the
mode, use the zeroconf mode
-> zeroconf mode tunnel type standard
3
Configure the tunnel source IP address (Loopback0 IP interface) for the GRE tunnel. To configure the
Loopback 0 IP interface, use the
-> ip interface Loopback0 address 10.1.2.3
Note. Ensure reachability to the Loopback0 IP address. If the Loopback0 address is not configured, the
operational status of mDNS or SSDP will be down.
4
Configure the remote tunnel endpoint IP address of the switch running as the responder. To configure
the responder IP address, use the
-> zeroconf responder-ip 10.0.1.5
5
Configure the access VLAN list. For any query packet generated by the responder, mDNS packet
comes in with a VLAN tag of 4095. These packets are flooded to the configured access VLAN list. To
configure the access VLAN list, use the
-> zeroconf access-vlan-list 7 8 9
Note. Maximum of 16 access VLANs is supported in a list.
OmniSwitch AOS Release 8 Network Configuration Guide
zeroconf mode command. For example:
zeroconf mdns admin-state
command. For example:
ip interface command. For example:
zeroconf responder-ip
zeroconf access-vlan-list
Bring Your Own Devices (BYOD) Overview
command. For example:
command. For example:
December 2017
zeroconf
and zeroconf ssdp
page 28-138