Configuring And Removing An Mld Static Neighbor - Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual

Configuring IP Multicast Switching
Restoring the MLD Version 1
To restore the MLD version to Version 1 (MLDv1) on the system if no VLAN or SPB service is specified,
use the ipv6 multicast version
-> ipv6 multicast version 0
Or, as an alternative, enter the following command to restore the MLD version to Version 1:
-> no ipv6 multicast version
You can also restore the MLD version to Version 1 (MLDv1) on the specified VLAN or SPB service by
entering:
-> ipv6 multicast vlan 2 version 0
-> ipv6 multicast service 10 version 0
Or, as an alternative, enter the following commands to restore the MLD version to Version 1:
-> no ipv6 multicast vlan 2 version
-> no ipv6 multicast service 10 version

Configuring and Removing an MLD Static Neighbor

MLD static neighbor ports receive all multicast streams on the designated VLAN or SPB service and also
receive MLD reports for the VLAN or SPB service. The following subsections describe how to configure
and remove a static neighbor port by using the
Configuring an MLD Static Neighbor
To configure a port as an MLD static neighbor port, use the
with the port option. For example, the following command configures port 1/1/13 in VLAN 2 as an MLD
static neighbor:
-> ipv6 multicast static-neighbor vlan 2 port 1/1/13
To configure an SPB Service Access Point (SAP) as an MLD static neighbor port, use the ipv6 multicast
static-neighbor command with the sap port option. For example, the following command configures
SAP port 1/1/23:10 that is bound to SPB service 10 as an MLD static neighbor:
-> ipv6 multicast static-neighbor service 10 sap port 1/1/23:10
In this example, 1/1/23:10 serves as a SAP ID, which is comprised of an access port number (1/1/23) and
an encapsulation value (10). SPB service 10 is mapped to SAP ID 1/1/23:10. Traffic received on access
port 1/1/23 that is tagged with VLAN 10 is encapsulated and then forwarded on service 10 through the
SPB network. Refer to
To create an MLD static neighbor entry on a link aggregate, use the linkagg parameter. For example:
-> ipv6 multicast static-neighbor vlan 2 linkagg 7
-> ipv6 multicast static-neighbor service 10 sap linkagg 10:100
Removing an MLD Static Neighbor
To reset the port so that it is no longer an MLD static neighbor port, use the no form of the
static-neighbor command with the vlan and port parameters. For example, the following command
removes port 1/1/13 with designated VLAN 2 as an MLD static neighbor:
OmniSwitch AOS Release 8 Network Configuration Guide
command by entering:
ipv6 multicast static-neighbor
Chapter 10, "Service Manager Commands,"
Configuring IPMSv6 on a Switch
ipv6 multicast static-neighbor
for more information.
December 2017
command.
command
ipv6 multicast
page 25-30