Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual page 46

Configuring Ethernet Ports
Note. The beacon LED feature does not affect the normal behavior of switch ports or traffic flow. It only
sets LED colors and behaviors for the uses listed above. If an actual alarm or issue is detected on the switch,
important LED status information related to the issue takes precedence and overrides beacon settings.
Note. The beacon LED feature is not supported on sub-ports 'b', 'c', or 'd' when an interface is operating in
4X10G mode. Additionally, only Solid mode is supported on sub-port 'a' for 4X10G interfaces.
LED Color and Mode Settings
•
LED Color - The color of the LED can be changed to yellow, white, red, magenta, green, blue, aqua, or
off.
•
Activity Mode - The LED will blink normally based on the port activity but the color of the LED can
be changed.
•
Solid Mode - The LED will not blink based on the port activity, it will always be solid. The color of
the LED can be changed.
-> interfaces 1/1/30 beacon admin-status enable
-> interfaces 1/1/30 beacon led-color magenta
-> interfaces 1/1/30 beacon led-mode solid
Beacon settings are saved and can be administratively enabled or disabled as needed at a later time. This
allows administrators to reuse previously configured LED settings without having to start over. Use the
show interfaces beacon
-> show interfaces beacon
Ch/Slot/Port
------------+-------------+--------------+------------
1/1/1A
1/1/2A
1/1/30A
1/1/31A
OmniSwitch AOS Release 8 Network Configuration Guide
command to view the beacon settings.
Admin-Stat LED-Color
Disable Magenta
Disable Blue
Enable Magenta
Enable Off
Configuring Ethernet Port Parameters
LED-Mode
Solid
Activity
Solid
Solid
December 2017 page 1-12