Alcatel-Lucent OmniSwitch 9900 Series Network Configuration Manual page 90

Configuring VLANs
Port 4/3 is now configured to carry packets tagged with VLAN 5, even though VLAN 5 is not the default
VLAN for the port.
To enable tagging on link aggregation groups, enter the link aggregation group identification number in
place of the slot and port number, as shown:
-> vlan 5 members linkagg 8 tagged
(For further information on creating link aggregation groups, see
Aggregation," or Chapter 9, "Configuring Dynamic Link
To remove 802.1Q tagging from a selected port or link aggregate, use the untagged parameter.
-> vlan 5 members linkagg 8 untagged
To display all VLANs, enter the following command:
-> show vlan port
Note. The link aggregation group must be created first before it can be set to use 802.1Q tagging.
OmniSwitch AOS Release 8 Network Configuration Guide
Chapter 8, "Configuring Static Link
Aggregation.")
December 2017
Assigning Ports to VLANs
page 4-8