Pedal Box; Brake Switch Mount - Factory Five Racing '33 Hot Rod Assembly Manual

Pedal Box


½", " sockets, ⅜",
9
/
16
Keys, Hammer, Vise or 2 pieces of 2 x 4, Razor knife or file or grinder, snap ring pliers,
driver.

Pedal Components, pedal box hardware.
 If using an automatic transmission or a hydraulic clutch some of these steps will not apply.
 Unpack the pedal box assembly. Now is a good time to paint all of the bare steel brackets.

The brake switch may look different than in the pictures.

The pedal box comes with two pedal switches, one for the brake lights and the other can be used
as a clutch safety switch (used to prevent starting the car while in gear) if desired.

Brake switch mount

Place the switch mount between the brake pedal mount tabs on the side closest to the brake pedal pivot
" hole through the brake switch mount hole and the pedal box.
3
holes and drill a
/
16
Attach the switch mount to the pedal box using the black #10 screw and locknut.
", ½", " wrenches, Drill,
11 9
/ /
32 16
www.factoryfive.com
", ¼", ½" Drill bit, ⅛",
3
/
16
108
508-291-3443
", ", " Hex
9 5
/ /
32 16
" nut
5
/
16