Ignition Switch Wiring - Factory Five Racing '33 Hot Rod Assembly Manual

Ignition switch wiring

 If you are using a one wire alternator with the chassis harness, the brown Alternator ignition power
wire is not necessary.
Locate the ignition switch wires and make the following connections to the ignition switch itself.
Ignition wiring
After you connect the wires to the correct terminals tape over the backside of the casing with electrical
tape to prevent electrical shorts.
BAT RED-HDLT SW 1 FEED
RED-IGN SW>SOL
ACC BRN-ACC FEED >IGN SW
BRN-ALTERNATOR IGN
START LT BLU-EFI CRANK
LT BLU-IGN SW>NS SW
IGNITION ORD-IGN FEED>IGN SW
199
www.factoryfive.com 508-291-3443