Table of Contents
Advertisement
Rear Coil-Over Shock Assembly
Snap ring pliers, ¾" wrench, ¾" socket, ratchet, ruler, marker, hack saw.
Rear shock kit
The rear shocks are pre-valved at the factory in compression and rebound for good street use. The
shocks can be adjusted in rebound as per Koni's instructions if so desired. The rear springs are 250lb.
Other springs are available for different ride characteristics.
WARNING! Incorrect assembly and maintenance of this part can cause serious injury or death.
If using the silver double adjustable shocks, these must be mounted with the body of the shock down.
Unpack the rear shocks, coil over's and hardware.
Double check the jam nut under the rod end and bump stop to make sure that it is tight.
Screw the spring seat down on the sleeve so it is closer to the unthreaded end. The center high part of the
set should be pointed away from the unthreaded end.
Slide the coil sleeve over the body of the damper beginning at the end which has the rubber bump stop.
The unthreaded end of the sleeve goes first so that it will sit on the snap ring on the shock body.
58
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
