Tail Lights - Factory Five Racing '33 Hot Rod Assembly Manual

Tail lights


Wire strippers, wire crimpers, electrical tape, drill,

Electrical system components, 33 tail light components.
" hole in the left side of the trunk to pass the harness wires into the trunk.
11
Drill an /
32
Install a grommet in the aluminum hole.
Pull the wire loom back on the wires.
Note which wires the license plate wires are connected to.
Cut the connector off the tail light wires which will also cut the license plate wires.
Push the tail light wires through the grommet into the trunk so they will reach the light.
Strip the ends of the tail light wires and the harness wires.
Wire the tail lights to the harness using either butt connectors or solder.
Cut the wire loom outside the trunk so that the loom ends at the grommet.
Put the wire loom on the wires in the trunk.
11 " hole in the right side trunk wall.
Drill an /
32
Install a grommet in the aluminum hole.
Pull the wire loom back on the wires.
Note which wires the license plate wires are connected to.
Tail light wire color
White
Red
Black
645
www.factoryfive.com 508-291-3443
" drill bit
11
/
32
Function
Ground
Turn/brake
Parking light