Table of Contents
Advertisement
Work from the middle towards the top and bottom then towards the side, smoothing the vinyl out on the
fiberglass. Trim the vinyl as you go so there is 1" of overhang that will go onto the back of the fiberglass
panel.
Do not trim the rollbar area yet.
Spray glue on the back of the side piece of vinyl.
Overlap the side piece on the rear vinyl and smooth the vinyl over the side of the fiberglass part.
Use a masking tape to get a straight in the corner going through the rollbar hole.
Cut through both vinyl pieces with a sharp razor knife along the straight edge of the masking tape.
Remove the scrap side piece then pull back the side piece to remove the scrap center piece.
Re-smooth the vinyl, if necessary spay more glue to ensure that I will stick.
Turn the rear cockpit cover over.
Spray the back of the fiberglass, edge vinyl and rollbar hole areas with spray glue.
668
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
