Factory Five Racing '33 Hot Rod Assembly Manual page 640

Push the included grommet onto the trunk latch release cable so that it is oriented as shown in the picture
above.
Spray some WD40™ on the cable and slide the grommet so that it is about two feet from the other end of
the cable.
 The following pictures show the body off the frame, this is done for easier viewing.
Run the release cable up behind the shock then down the 1.5" square tube.

Do not fasten the cable to the frame until after the cable is connected at both ends.
639
www.factoryfive.com 508-291-3443