Fan Wiring; Alternator - Factory Five Racing '33 Hot Rod Assembly Manual

Cut the yellow and white rear turn signal light wires off the turn signal connectors that are for the dash
turn signal switch so that the turn signal lights do not back feed and light the front turn signals when the
brakes are pressed.

Fan Wiring

Follow the directions in the chassis harness instructions
Carbureted Engine
Run the coil wires with the alternator wires and gauge sender wires for use with the coil.
Fuel Injected Engine
Leave the coil and crank wires in the footbox and connect them to the power wires for the EFI harness
according to the EFI harness instructions.
If the EFI harness uses its own wires for the fuel pump, remove the fuse for the fuel pump from the fuse
panel and cut and solder the fuel pump wire from the EFI harness onto the chassis harness wire.
 If using a Coyote engine, refer to the available "Coyote Install" instructions.

Alternator

Run the alternator wires along the top of the engine to the alternator.
202
www.factoryfive.com 508-291-3443