Table of Contents
Advertisement
Attach the clevis using a ¼" flange head screw and locknut along with a
Tighten the locknut so that the clevis can still rotate freely but there is not a lot of slop, this will bend the
clevis slightly.
Install the cable ball end into the outer most clevis. Test the door handle. Adjustment can be made on the
cable sheath threaded end if the latch lever does not return to its position or the latch does not unlock.
Repeat for the opposite side using the left hand wound spring (34147).
Rollbar
",
", ½" drill bits, 1" or 1.5" hole saw, drill, marker, measuring tape
3
5
/
/
16
16
Rollbar fasteners, rollbar, rear cockpit cover
The rollbar has been designed so that it will fit both inside the hardtop and can be used with the car a s
a Roadster.
Hardtop Rollbar Installation
When the rollbar is sitting down on the frame there is 2"-3" clearance between the top of the rollbar
and the Hardtop. It is possible to have more than one height mounting location for the rollbar if you
plan to change back and forth between the Hardtop and the Roadster so that the rollbar is high and
close to the Hardtop and then lower when used in the roadster configuration so it does not look
strange with a high rollbar.
Slide the roll bar down into the frame mounts.
Place the Hardtop on the body and attach it using a couple of the rear mount points.
594
www.factoryfive.com
508-291-3443
" wrench and
" Hex key.
7
3
/
/
16
32
Advertisement
Table of Contents
